Naar de inhoud
OneKitly

Four Points of Service Level Cost 41 % More Stock

Gepubliceerd op 22-9-2026 · 3 min leestijd · Zakelijke tools

Lena Hoffmann

Lena Hoffmann — Redacteur wetenschap en onderwijs bij OneKitly

Wiskunde · Natuurkunde

Getoetst aan 2 bronnen

Profiel bekijken →
Kort gezegd

Safety stock exists to absorb two kinds of surprise — demand higher than forecast, and a delivery later than promised — and the formula multiplies a z-score by the combined standard deviation of both. The z-score is the only place the service level enters, and it is not linear. For demand of 100 a day with a standard deviation of 20, a ten-day lead time with a standard deviation of 2 days, a 95 % service level gives z = 1.645 and 346 units of safety stock. Raise the target to 99 % and z becomes 2.326: the safety stock jumps to 488, forty-one per cent more inventory for four points of availability. Push toward 99.9 % and the curve steepens again. That is the whole economics of the decision — the first ninety points are nearly free and the last few are where the working capital goes.

Advertentie

Going from a 95 % service level to 99 % raises the z-score from 1.645 to 2.326 and the safety stock from 346 units to 488. The last few points of availability are the expensive ones.

The z-score is a normal table, and that is an assumption

Turning a service level into a z-score assumes demand is normally distributed. Real demand often is not: a product with occasional bulk orders has a long right tail, and the normal curve underestimates exactly the events safety stock exists to survive. The formula still helps — it ranks products correctly and sizes the trade-off — but a 99 % target on a skewed product will not deliver 99 % availability. Where the history shows fat tails, the honest move is to raise the target above what the theory asks for, and to say that is what you are doing.

Lead-time variability is usually the bigger half

The combined standard deviation adds the demand variation over the lead time to the demand level multiplied by the lead-time variation — and the second term is squared against a much larger number. On the figures above, two days of uncertainty on a ten-day lead multiplied by 100 units a day contributes more to the total than the demand noise does. The practical consequence is that negotiating a more reliable delivery window usually cuts safety stock faster than forecasting demand better, and it is often the cheaper of the two projects.

Demand 100/day (σ 20), lead time 10 days (σ 2)
Service levelzSafety stockReorder point
95 %1.6453461,346
99 %2.3264881,488

Uitgewerkt met onze eigen calculator

Veiligheidsvoorraadcalculator

Gegeven

Serviceniveau (%)
190
Gemiddelde vraag per dag
80
Levertijd (dagen)
14
Standaardafwijking van de dagvraag (σ_d)
24
Standaardafwijking van de levertijd (σ_LT, dagen)
4

Resultaat

Servicefactor Z
3,719
Veiligheidsvoorraad (stuks)
1.237
Bestelpunt (stuks)
2.357

Deze cijfers komen uit de calculator hieronder, ze zijn niet met de hand ingetypt — ze worden opnieuw berekend telkens als de tool verandert.

Reken het door met je eigen cijfers →
Advertentie

Veelgestelde vragen

What service level should I target?
Not one number for the whole catalogue. The right target compares the cost of holding one more unit against the cost of not having it — which differs enormously between a cheap consumable a customer will wait for and an expensive part that stops a production line. Classify the range first, then set a target per class. A single 98 % across everything overstocks the cheap items and understocks the critical ones simultaneously.
Is the service level the same as the fill rate?
No, and confusing them flatters the numbers. The service level in this formula is the probability of not running out during a replenishment cycle — a per-cycle chance. The fill rate is the proportion of demand actually satisfied from stock, measured in units. A 95 % cycle service level usually produces a fill rate well above 95 %, because most stockouts are short and cost only a few units. Reporting one and computing the other is a common way to appear to have missed a target that was never the one being measured.

Artikelen die je misschien interesseren

Alle gidsen →
UitlegA 30 % Sell-Through Is Excellent or Alarming, and the Missing Word Is "When"120 units sold out of 400 received is 30 %. Whether that is a success depends entirely on how long it took, and the rate on its own does not carry the answer.UitlegThe Reorder Point Is a Quantity That Answers a Question About TimeSelling 100 a day with a ten-day lead time and 300 units of safety stock, you reorder at 1,300 — not because 1,300 is a comfortable level, but because that is what ten days of selling costs.UitlegDe wortelformule van de optimale bestelgrootte, en waar hij ophoudt te kloppenEOQ = √(2DS/H) brengt de bestelkosten en de voorraadkosten in balans. De nuttigste eigenschap van de formule is hoe vlak de kostencurve rond het optimum ligt — en haar vier breekpunten zijn staffelkortingen, onregelmatige vraag, een eindige aanvulsnelheid, en de twee invoeren die niemand kan meten.UitlegCost of Goods Sold Is What Left the Shelf, Not What You BoughtOpening stock 40,000, purchases 120,000, closing stock 35,000 — the cost of goods sold is 125,000, and it is larger than the purchases because the shelf gave up 5,000 of what was already there.UitlegThe Count Says 48,200 and the Books Say 50,000A gap of 1,800 is a shrinkage rate of 3.6 %. The percentage is the number that travels; the absolute figure is the one that pays for the fix.UitlegGMROI: the Inventory Number That Outranks MarginGross margin return on inventory investment divides gross margin by the cash tied up in stock. It exists because margin alone ranks products wrongly: a 60% margin turning twice a year loses to a 25% margin turning twelve times.

Vergelijkbare tools

Bronnen

Een fout in dit artikel gezien?