650 Ohms Does Not Exist, So You Build It From Two
Published 11/20/2026 · 3 min read · Developer tools
Daniel Okonkwo — Front-end developer and tech writer at OneKitly
Web performance · File formats
Checked against 2 sources
Resistors are manufactured in a fixed set of values chosen so that consecutive ones differ by roughly the tolerance band, which for the common E12 series means twelve values per decade: 100, 120, 150, 180, 220, 270, 330, 390, 470, 560, 680, 820. A design calling for 650 ohms finds nothing on the shelf and reaches for series addition instead: 220 plus 430 is 650, and so is 100 plus 220 plus 330. Because series resistances add directly, any target can be built from parts in the drawer at the cost of board space and a few extra solder joints.
Standard resistor values jump 220, 270, 330, 390, 470. Series resistances simply add, so 220 + 430 makes 650 and so does 100 + 220 + 330.
Why the values are spaced the way they are
Each E12 value is about 21% above the last, which is the twelfth root of ten, so twelve steps multiply by exactly ten. That spacing matches a 10% tolerance: the top of one band nearly touches the bottom of the next, so every possible resistance is covered by some part without stocking values that overlap. The E24 series halves the step for 5% parts, E96 does it again for 1% parts, and each finer series exists because the tolerance shrank rather than because anybody wanted more numbers.
Tolerances add in a way that helps
Two 5% resistors in series give a total whose worst case is also 5% out, since both errors are proportional to their own values. In practice the errors are independent and partly cancel, so the expected deviation of the pair is closer to 3.5% — the square root of the sum of the squares rather than the plain sum. Adding parts therefore does not degrade accuracy and slightly improves it on average, which is the opposite of what most people assume when they see three resistors where one was expected.
| Combination | Total | Parts |
|---|---|---|
| 220 + 430 | 650 Ω | 2 |
| 100 + 220 + 330 | 650 Ω | 3 |
| 680 alone | 680 Ω | 1, and 4.6% high |
Frequently asked questions
- Would 680 ohms have been close enough?
- Usually yes, and it is worth checking before adding parts. A single 680 is 4.6% above target, which is inside the tolerance band of a 5% part and therefore indistinguishable from a nominal 650 that happened to be manufactured high. Pull-up resistors, LED current limiters and biasing networks all tolerate that comfortably. Timing networks and precision dividers do not, and those are the cases where the extra part earns its place.
- What about putting them in parallel instead?
- Parallel gives a total below the smallest part, which is the tool for reaching values between stocked ones from below. Two 1.3k in parallel make 650, using one value twice — often more convenient than sourcing two different parts. Parallel also halves the power dissipated in each resistor, so it is the standard trick when a single part would run hot, and series is the standard trick when the voltage across one part would exceed its rating.
Articles you may find interesting
All guides →Related tools
Sources
Spotted a mistake in this article?