Skip to content
OneKitly

A Base of Ten and a Base of Twenty Can Give the Same Area

Published 11/9/2026 · 3 min read · Everyday calculators

Marco Bianchi

Marco Bianchi — Home, DIY & motoring writer at OneKitly

Renovation · Materials

Checked against 2 sources

View profile →
In short

The area of a triangle is half the base times the perpendicular height, and only the product of those two matters. A base of 10 with a height of 6 gives 30; so does a base of 20 with a height of 3, and so would a base of 60 with a height of 1. The three shapes range from nearly equilateral to a sliver, and the formula reports them as identical because it is measuring how much surface they cover rather than what they look like. Anything that changes the shape without changing base or height — sliding the apex sideways along a line parallel to the base — leaves the area untouched.

Advertisement

Base 10 with height 6 and base 20 with height 3 both give 30. The two triangles look nothing alike, and the formula cannot tell them apart.

Any of the three sides can be the base

Pick a different side and the height changes to match, and the product stays the same — that is what makes the choice free rather than arbitrary. On site, the useful consequence is that you can take whichever side is easiest to measure and whichever height you can actually reach. For a triangular flowerbed against a wall, the wall side is the obvious base; for a gable end, the horizontal is. The wrong choice is not incorrect, only inconvenient, and picking the side that lets you drop a perpendicular inside the shape saves the awkward case where the foot of the height lands outside it.

When you have three sides and no height

Measuring a height in the field often means holding a tape square to a line that is not there. Three side lengths are far easier to obtain, and Heron's formula turns them straight into an area without any perpendicular being constructed. It is the standard method for irregular plots, where a surveyor breaks the boundary into triangles, measures every side, and adds the results. The cost is arithmetic rather than fieldwork, which is the right trade in every era since the pocket calculator and the wrong one before it.

Height
Three triangles of area 30
BaseHeightArea
10630
20330
60130

Worked with our own calculator

Triangle area calculator

Given

Base
20
Height
12

Result

Area
120

These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.

Run it on your own figures →
Advertisement

Frequently asked questions

Why is it half the parallelogram?
Because two copies of the triangle make one exactly. Rotate a copy by half a turn and set it against the original along any side: the two fit together into a parallelogram with the same base and the same height, and the triangle is therefore half of it. The demonstration works for every triangle including the obtuse ones, needs no algebra, and is the reason the same 'half base times height' shows up in the area of a sector, of a trapezoid decomposed into triangles, and in the first integral anyone computes.
Can a triangle have a base longer than its perimeter allows?
No, and the constraint is the reason a calculator taking three sides can refuse an answer. Each side must be shorter than the sum of the other two, or the shape does not close — sides of 1, 2 and 10 describe nothing. A calculator working from base and height never meets this problem, because those two quantities are independent and any pair describes a real triangle. That difference is worth knowing when a tool returns an error: the fault is in the measurements rather than in the arithmetic, and one of the three sides has been written down wrong.

Articles you may find interesting

All guides →

Related tools

Sources

Spotted a mistake in this article?