Skip to content
OneKitly

A Sprinter's First Stride Needs More Grip Than Their Own Weight

Published 11/11/2026 · 3 min read · Sport calculators

Aisha Karim

Aisha Karim — Fitness & running writer at OneKitly

Running · Training

Checked against 2 sources

View profile →
In short

Force is mass times acceleration, and for a runner the mass is fixed, so every gain in acceleration is bought with force pushed against the ground. A 70 kg athlete reaching 10 m/s in two seconds averages 5 m/s², which needs 350 newtons of horizontal push — half of their 687 N body weight. The first stride out of the blocks reaches nearer 10 m/s², demanding around 700 N, which is more than the athlete weighs. Since the available grip is the weight multiplied by the friction coefficient, that stride is only possible because spikes push the coefficient above 1. On a smooth floor the same effort produces a slip, not a start.

Advertisement

70 kg accelerating at 5 m/s² needs 350 N, half a body weight. Off the blocks the acceleration doubles and so does the demand, which is why spikes exist.

Why the fastest runners are not the strongest

The equation puts mass on both sides of the athlete's problem: adding muscle raises the force available and raises the mass that force has to move. What matters is the ratio, which is why sprinters converge on a build rather than simply getting bigger, and why a 90 kg athlete needs 450 N for the same 5 m/s² that costs a 70 kg athlete 350. Bodyweight also sets the grip ceiling, so heavier runners get a proportionally higher limit — the two effects nearly cancel, and what remains is how fast the muscle can produce its force rather than how much it can produce.

Standing still is not free either

Holding a 20 kg load steady costs 196 N of upward force just to cancel gravity, while accelerating that same load sideways at 1 m/s² costs 20 N. The gap between those two numbers explains why carrying is exhausting and pushing a trolley is not: gravity never stops asking, whereas horizontal acceleration only asks while the speed is changing. Training that ignores the distinction ends up measuring endurance when it meant to measure power, and any programme built around a single number will drift toward whichever of the two the exercise happens to load.

Acceleration
What a 70 kg body has to push
EffortAccelerationForce
Jogging start2.5 m/s²175 N
Sprint, first two seconds5 m/s²350 N
First stride from blocks10 m/s²700 N

Worked with our own calculator

Force calculator (F = ma)

Given

Mass (kg)
10
Acceleration (m/s²)
9.8

Result

Force (N)
98

These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.

Run it on your own figures →
Advertisement

Frequently asked questions

Why is the acceleration highest at the start?
Because muscle produces less force the faster it is already shortening. At standstill the leg can push with everything it has; at 10 m/s the same muscle is contracting so quickly that its available force has collapsed, which is why top speed arrives as a plateau rather than as a limit imposed from outside. Air resistance adds to that at the top end but is not the main brake — the force-velocity relationship inside the muscle is, and it is the reason a 100 m race is mostly won in the first thirty metres.
How does this compare with a car?
The equation is identical and the numbers are twenty times larger. A 1400 kg car accelerating at 3 m/s² needs 4200 N at the contact patches, and it faces the same grip ceiling a runner does — tyre against asphalt tops out near a coefficient of 1, so around 1 g is the practical limit for a road car, and everything beyond that is aerodynamics pressing the car down. A sprinter briefly exceeds what a family car can do, using four small patches of rubber spikes instead of four large ones of tread.

Articles you may find interesting

All guides →

Related tools

Sources

Spotted a mistake in this article?