The Mean Absolute Deviation Lost a Fight It Should Have Won
Published 11/13/2026 · 3 min read · Everyday calculators
Daniel Okonkwo — Front-end developer and tech writer at OneKitly
Web performance · File formats
Checked against 2 sources
Ask how far a typical value sits from the average and the direct answer is the mean absolute deviation: add up the distances, ignore the signs, divide by how many there are. For 4, 8, 15, 16, 23, 42 the mean is 18 and that average distance is 9.67. The standard deviation for the same data is 13.49, a full 40% larger, because squaring gives the far-out points extra weight before the square root pulls the answer back. Neither is wrong; they answer different questions, and the one almost everybody is actually asking is the first.
For 4, 8, 15, 16, 23, 42 the average distance from the mean is 9.67 and the standard deviation is 13.49. The first one is what the question actually asked.
Eddington against Fisher, and who was right
The astronomer Arthur Eddington preferred the absolute deviation and said so in print; Ronald Fisher showed in 1920 that for perfectly normal data the standard deviation extracts more information from the same sample, and the profession followed Fisher. Forty years later Tukey pointed out the missing condition: real data is never perfectly normal, and a contamination of a fraction of a per cent by wild values is enough to reverse the ranking. Both men were right about the case they described, and the textbooks kept only one of the two cases.
When the choice actually changes a decision
In stock control, safety margins are usually set at a multiple of the spread, so choosing the larger measure books more stock. In server monitoring, an alert threshold set from the standard deviation fires later after a single bad reading has inflated it, while a threshold from the absolute deviation reacts more evenly. Neither behaviour is universally better, but the two produce different amounts of inventory and different numbers of pages at three in the morning, which makes the choice an engineering decision rather than a matter of taste.
| Data | Mean absolute deviation | Standard deviation |
|---|---|---|
| 2, 4, 6, 8, 10 | 2.4 | 3.16 |
| 4, 8, 15, 16, 23, 42 | 9.67 | 13.49 |
| Ratio | 1 | 1.25 to 1.4 |
Worked with our own calculator
Mean absolute deviation (MAD) calculator
Given
- Numbers (comma-separated)
- 2, 4, 6, 8, 10
Result
- Mean
- 6
- Mean absolute deviation
- 2.4
These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.
Run it on your own figures →Frequently asked questions
- Is there a fixed conversion between the two?
- Only for a normal distribution, where the standard deviation is 1.2533 times the mean absolute deviation — the square root of pi over two. Any other shape breaks the ratio: the six-number example here lands at 1.396 because it has one value far out on the right. Seeing a ratio much above 1.25 is itself a signal that the data has a heavy tail, which makes the comparison of the two a free diagnostic rather than a redundancy.
- How is this different from the median absolute deviation?
- The one described here averages the distances from the mean; the median absolute deviation takes the median of the distances from the median, which is far more robust again. Both are abbreviated MAD, which causes real confusion in papers and in code. The median version ignores up to half the data being corrupted before it moves at all, at the cost of using very little of the information in clean data — the same trade the median itself makes against the mean.
Articles you may find interesting
All guides →Related tools
Sources
Spotted a mistake in this article?