Skip to content
OneKitly

The Range of Five Parts Divided by 2.326 Is a Standard Deviation

Published 11/17/2026 · 3 min read · Business tools

Marco Bianchi

Marco Bianchi — Home, DIY & motoring writer at OneKitly

Renovation · Materials

Checked against 2 sources

View profile →
In short

Before calculators reached the shop floor, quality control needed a measure of spread that a machinist could work out between parts. The range — largest minus smallest — is that measure, and dividing it by a constant that depends only on the sample size converts it into an estimate of the standard deviation. For samples of five the constant is 2.326, so a batch measuring 9.8, 10.0, 10.1, 10.2 and 10.4 has a range of 0.6 and an estimated standard deviation of 0.258 against a true 0.224. One subtraction and one division replace squaring five numbers, and the answer is close enough to act on.

Advertisement

Five measurements spanning 0.6 mm give an estimated standard deviation of 0.258 with one division. The real value is 0.224, and the shop floor never needed a calculator.

Why the divisor grows with the sample

The more parts you measure, the further apart the extremes are likely to fall, even though the underlying process has not changed. Two measurements straddle about one standard deviation on average; five straddle about 2.33; ten straddle over three. The constant simply undoes that growth, and it is why a range from a sample of five cannot be compared with a range from a sample of ten without correction. Charts fix the sample size for exactly this reason: keep it constant and the ranges are comparable day after day with no arithmetic at all.

What a control chart actually watches

Two things at once: whether the average has drifted, and whether the spread has widened. A tool wearing down moves the average without touching the range; a loose fixture widens the range without moving the average. Watching only the mean misses half the failures, which is why the range chart sits underneath the average chart on the same sheet and is read first. A process can be perfectly centred and completely out of control at the same time.

Divisor
The divisor by sample size
Sample sizeDivisorUse
21.128Paired checks
42.059Short runs
52.326The classic chart

Worked with our own calculator

Range calculator

Given

Numbers (comma-separated)
4, 8, 17, 18, 28, 53

Result

Range
49
Minimum
4
Maximum
53

These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.

Run it on your own figures →
Advertisement

Frequently asked questions

Is the estimate always this rough?
It is unbiased on average and noisy on any single sample, which is a different thing from rough. Over many samples of five the range divided by 2.326 lands on the true standard deviation; on one sample it can be out by a fifth in either direction, as the example here shows. Charts get around this by pooling twenty or twenty-five samples before setting limits, which is why a control chart cannot be started on the first morning of production.
Why not just use the standard deviation now?
Many plants do, and the charts are named accordingly. The range version survives because it is readable: an operator can see that today's spread is twice yesterday's without trusting a computed number, and a chart people understand gets filled in. There is also a technical argument — the range reacts faster to a sudden widening in small samples — but the honest reason is usually that the method has to be operated by the person at the machine, and simplicity is a feature of the system rather than a limitation of the maths.

Articles you may find interesting

All guides →

Related tools

Sources

Spotted a mistake in this article?