You Can Measure the Speed of Light With a Bar of Chocolate
Published 10/28/2026 · 3 min read · Everyday calculators
Lena Hoffmann — Science & education writer at OneKitly
Mathematics · Physics
Checked against 2 sources
Wave speed is frequency times wavelength, and the trick is that a microwave oven hands you the frequency for free — it is printed on the back, 2 450 MHz on almost every domestic unit. Take out the turntable, lay a bar of chocolate across the floor of the oven and heat it for twenty seconds. It melts in patches, not evenly, because the waves bounce off the metal walls and form a standing pattern with fixed hot spots. Measure between two melted spots: about 6.1 cm (2.4 in). That is half a wavelength, so the full wavelength is 12.2 cm, and 2.45 GHz × 0.1224 m gives 299 880 000 m/s — the speed of light, to within a twentieth of a percent.
Melted spots 6.1 cm apart, times a microwave's 2.45 GHz, times two: 300 million metres per second, from a kitchen appliance and a ruler.
The turntable exists because of this
Hot spots 6.1 cm apart inside a box 30 cm wide means roughly five of them across the cavity, and the cold zones between are genuinely cold. Left still, a plate of food would come out scalding in a few rings and refrigerated in between — which is exactly what happens when the turntable fails. The rotation drags every part of the dish through the hot spots in turn, averaging the exposure. Ovens without a turntable instead use a spinning metal vane near the waveguide to stir the pattern itself, which achieves the same thing by moving the hot spots rather than the food.
The same product, two very different speeds
Sound and light obey the same formula and differ by a factor of nearly a million in the answer. That is why a 20 Hz note — the bottom of hearing, the register of a cathedral organ's lowest pipe — stretches over 17 m, longer than most rooms, while a radio wave at five million times that frequency is only 3 m long. The room-sized wavelength of deep bass is the reason subwoofer placement is so fussy: the wave does not fit in the room, so the room decides where it is loud, and moving the speaker a metre changes which corner rumbles. The chocolate experiment is the same physics made visible, at a scale you can put a ruler on.
| Wave | Frequency × wavelength | Speed |
|---|---|---|
| Microwave oven | 2.45 GHz × 12.24 cm | 299 880 km/s |
| FM radio | 100 MHz × 3 m | 300 000 km/s |
| Concert A in air | 440 Hz × 78 cm | 343 m/s |
| Lowest audible note | 20 Hz × 17.15 m | 343 m/s |
Worked with our own calculator
Wave speed calculator
Given
- Frequency (Hz)
- 50
- Wavelength (m)
- 6.8
Result
- Wave speed (m/s)
- 340
These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.
Run it on your own figures →Frequently asked questions
- Why measure between melted spots and then double it?
- Because a standing wave delivers energy at both its crests and its troughs. Heating depends on the square of the field strength, which is large wherever the field swings hardest in either direction, so the hot spots repeat twice per wavelength rather than once. The distance you measure between adjacent melted patches is therefore half a wavelength, and doubling it recovers the full figure. Skipping the doubling is the classic way to get half the speed of light and conclude that the experiment failed.
- Does the speed change inside the food?
- Yes, and substantially — which is why the measurement is taken from the pattern in the empty cavity, not from inside the bar. Waves slow down in any medium denser than vacuum, and water slows microwaves considerably, so the wavelength inside a wet food is much shorter than 12.2 cm. That shortening is also why microwaves cook from a shallow depth inwards rather than all the way through: the energy is absorbed within the first centimetre or two of moist food, and the middle of a thick portion heats by ordinary conduction from there, at ordinary conduction speeds.
Articles you may find interesting
All guides →Related tools
Sources
Spotted a mistake in this article?