Eighty Per Cent Five Times Over Leaves a Third
Gepubliceerd op 6-10-2026 · 3 min leestijd · Dagelijkse calculators
Lena Hoffmann — Redacteur wetenschap en onderwijs bij OneKitly
Wiskunde · Natuurkunde
Getoetst aan 2 bronnen
Percent yield is what you got divided by what the equation said was possible: 8 ÷ 10 = 80 %. Read once it sounds respectable, and for a single step it is. The number that matters in a long preparation is the product of all the steps, because each one takes its cut of what the previous one delivered. Five steps at 80 % leave 0.80⁵ = 32.8 % of the starting material, and five steps at 90 % leave 59.0 % — so a ten-point improvement on every step nearly doubles the final quantity. That is why a route with fewer steps often beats a route with better individual yields, and why the figure worth optimising is the overall one rather than the best line in the notebook.
8 grams obtained where 10 were possible is an 80 % yield. Chain five such steps and 32.8 % of the starting material reaches the end — which is why a long synthesis is judged step by step.
The theoretical figure comes from the limiting reagent
The denominator is not the mass of everything put in; it is the mass of product that the scarcest reactant could possibly make, once the balanced equation has been used to convert moles of that reactant into moles of product. Choosing the wrong reactant as the limiting one gives a denominator that is too large or too small, and the resulting percentage is not a measure of anything. The check is arithmetic and quick: divide each reactant's moles by its coefficient in the equation, and the smallest quotient identifies the limiting one — whichever reactant looks heaviest on the balance.
A yield above a hundred per cent is a warning, not a result
Matter is conserved, so no reaction can produce more product than its stoichiometry allows. A calculated 104 % therefore says something is wrong with the measurement rather than remarkable about the chemistry, and the usual culprit is solvent that has not fully evaporated — a wet solid weighs more than a dry one and the balance cannot tell the difference. Residual reagent, an inorganic salt carried through from a work-up, and an arithmetic slip in the theoretical figure account for most of the rest. Dry to constant mass before recording a yield, and treat any figure over about 100 % as an instruction to repeat the weighing rather than a number to report.
| Yield per step | After five steps |
|---|---|
| 80 % | 32.8 % |
| 90 % | 59.0 % |
| 95 % | 77.4 % |
Uitgewerkt met onze eigen calculator
Rendementcalculator (%)
Gegeven
- Werkelijke opbrengst
- 8
- Theoretische opbrengst
- 10
Resultaat
- Rendement (%)
- 80%
Deze cijfers komen uit de calculator hieronder, ze zijn niet met de hand ingetypt — ze worden opnieuw berekend telkens als de tool verandert.
Reken het door met je eigen cijfers →Veelgestelde vragen
- Is a low yield always a failure?
- No, and treating it as one leads to the wrong optimisations. What matters is the cost and scarcity of what was lost: throwing away eighty per cent of a cheap and abundant starting material to obtain a difficult product cleanly can be entirely rational, while losing twenty per cent of something rare is not. A yield figure is only interpretable next to what the step was for, how many alternatives exist, and how much of the loss is recoverable — unreacted starting material recovered from a column is not the same loss as material destroyed.
- Does the same idea apply outside chemistry?
- Yes, wherever a process has stages that each pass on a fraction. A manufacturing line with six inspection points at 95 % each delivers 73.5 % of what it started, a recruitment funnel with five stages at 50 % delivers about 3 %, and a data pipeline that drops two per cent at each of ten hops arrives with 81.7 %. In every case the individual figures look acceptable and the product does not, which is why the useful habit is to multiply the chain before deciding that any one stage is the problem.
Artikelen die je misschien interesseren
Alle gidsen →Vergelijkbare tools
Bronnen
Een fout in dit artikel gezien?