Road Salt Stops Working at Minus 21, and Here Is the Arithmetic
Gepubliceerd op 11-11-2026 · 3 min leestijd · Dagelijkse calculators
Marco Bianchi — Redacteur wonen, klussen en auto bij OneKitly
Verbouwen · Materialen
Getoetst aan 2 bronnen
Molality counts moles of dissolved substance per kilogram of solvent, and it is the concentration that freezing-point calculations demand. A kilogram of table salt is 17.11 moles, so dissolved in ten kilograms of water it gives 1.711 mol/kg. Salt splits into two ions, doubling the particle count, and water drops 1.86 °C per mole of particles per kilogram — so the mixture freezes at −6.4 °C instead of 0. Push further and the return shrinks: the lowest point salt can reach is −21.1 °C at 23% salt by weight, and below that the salt itself starts crystallising out. Colder roads need calcium chloride or grit.
A kilo of salt in ten kilos of water is 1.711 mol/kg, and two ions per unit drop the freezing point by 6.4 °C. Past a certain concentration, more salt buys nothing.
Why molality and not molarity
Molarity divides by the volume of the finished solution, and volume changes with temperature — the very thing under study when you are computing a freezing point. A litre of brine at 20 °C is not a litre at −5 °C, so a molarity measured warm no longer describes the cold mixture. Mass does not care about temperature, so molality stays fixed from the mixing bucket to the frozen road. Every colligative property — freezing point, boiling point, vapour pressure — is written in molality for that reason, and every one of them is written in molarity by somebody in a hurry at least once a term.
The linear law is a beginner's law
Multiply 1.86 by the particle molality and you get the depression — but only while the solution is dilute. At the salt limit of 23% by weight the formula predicts about −19 °C while the real eutectic is −21.1 °C, because ions in a crowded solution stop behaving independently. The gap is small enough to ignore on a driveway and large enough to matter in a laboratory, which is the usual fate of an idealised law. Below the eutectic no amount of salt helps: the mixture freezes as a solid block of ice and salt together, and the road needs something else.
| Salt per 10 kg water | Molality | Freezes at |
|---|---|---|
| 250 g | 0.428 mol/kg | −1.6 °C |
| 500 g | 0.856 mol/kg | −3.2 °C |
| 1 kg | 1.711 mol/kg | −6.4 °C |
Uitgewerkt met onze eigen calculator
Molaliteitscalculator
Gegeven
- Mol opgeloste stof (of gebruik de massa hieronder)
- 1
- Massa opgeloste stof (optioneel)
- 5 g
- Molaire massa (g/mol)
- 5
- Massa van het oplosmiddel
- 500
- Eenheid oplosmiddel
- kilogram
Resultaat
- Molaliteit
- 0,002 mol/kg
- Gebruikt aantal mol opgeloste stof
- 1
Deze cijfers komen uit de calculator hieronder, ze zijn niet met de hand ingetypt — ze worden opnieuw berekend telkens als de tool verandert.
Reken het door met je eigen cijfers →Veelgestelde vragen
- Does spreading more salt work faster?
- Up to a point, and then it wastes money and damages plants. Salt only works once dissolved, so a heavy scattering on dry ice sits there until enough water appears to take it up. Road crews often wet the salt before spreading precisely to skip that delay. Doubling the dose halves nothing about the time; it only lowers the temperature the melt can survive, and once the road is above that temperature the extra grains do nothing but wash into the verge.
- Is antifreeze the same idea?
- The same physics with a different molecule. Ethylene glycol does not split into ions, so each molecule counts once rather than twice, but it mixes with water in any proportion — which salt cannot do — so the concentration can go far higher. A half-and-half mix protects to about −37 °C, and the curve turns back up past 60% glycol, so more is genuinely worse. That non-monotonic behaviour surprises people every winter, and it is why the bottle prints a ratio instead of telling you to pour generously.
Artikelen die je misschien interesseren
Alle gidsen →Vergelijkbare tools
Bronnen
Een fout in dit artikel gezien?