180 Singles and 45 Home Runs Score Identically
Published 11/5/2026 · 3 min read · Sport calculators
Total bases weight each hit by how far it advances the batter: one for a single, two for a double, three for a triple, four for a home run. A season of 120 singles, 30 doubles, 5 triples and 25 home runs adds to 295 bases, which over 550 at-bats gives a slugging average of .536. The weighting means very different seasons can land on the same figure — 180 singles and no extra-base hits gives 180 bases, and so does 45 home runs and nothing else. Both slug .327, and no reader of that number alone could tell a contact hitter from a power hitter who never reaches base any other way.
Both give 180 total bases and a slugging average of .327. The statistic counts bases reached and is indifferent to how they were reached.
The weights are a convention, not a measurement
Counting a home run as four times a single is a choice made when the statistic was invented, and nothing in the game supports it. Measured by how many runs each outcome actually produces, a home run is worth closer to two and a half singles, not four — a single often advances runners and a home run always scores everyone on base, but the gap between them is smaller than the weighting implies. Later statistics were built specifically to fix this, assigning weights taken from a century of recorded play instead of from the geometry of the diamond. Slugging survives because it is simple to compute by hand, which is what mattered when it was defined.
What the denominator quietly excludes
Slugging divides by at-bats, and at-bats exclude walks. A batter who reaches base sixty times by being walked has those appearances erased from the calculation entirely, so patience is invisible to this statistic and can even improve it by removing plate appearances that might have ended badly. That is why slugging is almost never quoted alone: paired with on-base percentage, which does count walks, the two together describe both what a batter does with the bat and how often the bat is needed. The habit of adding them into a single figure is crude — the units do not match — and persists because the sum ranks players about as well as far more careful measures do.
| Line | Total bases | Slugging |
|---|---|---|
| 120 1B, 30 2B, 5 3B, 25 HR | 295 | .536 |
| 180 singles only | 180 | .327 |
| 45 home runs only | 180 | .327 |
Worked with our own calculator
Total bases (TB) calculator
Given
- Singles (1B)
- 120
- Doubles (2B)
- 30
- Triples (3B)
- 5
- Home runs (HR)
- 25
- At-bats (AB, optional → SLG)
- 550
Result
- Total bases (TB)
- 295
These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.
Run it on your own figures →Frequently asked questions
- Why is slugging written as a three-digit decimal?
- Convention, and a very old one. Baseball averages have been written to three places and read aloud as whole numbers — .327 spoken as three twenty-seven — since the nineteenth century, when the format made a rate look like a score. The leading zero is dropped because the value can never reach one for a batting average, though slugging can exceed one and occasionally does: four bases from a single at-bat gives 4.000, and a season above 1.000 has happened. The notation therefore breaks for exactly the statistic it is most often used on, which nobody has bothered to fix.
- Do total bases include walks or stolen bases?
- Neither. The statistic counts only bases reached on a hit, so a walk contributes nothing and a stolen base afterwards contributes nothing either, even though both put the runner in exactly the same place. That narrowness is deliberate: total bases is meant to measure what the batter did with the bat, and reaching second by stealing is a different skill credited elsewhere. The consequence is that a fast, patient player can be extremely valuable while looking ordinary in this column, which is precisely the gap that later all-in-one statistics were designed to close.
Articles you may find interesting
All guides →Related tools
Sources
Spotted a mistake in this article?