Skip to content
OneKitly

Two Per Cent and Twelve Per Cent Differ by a Factor of Fifteen

Published 11/3/2026 · 4 min read · Finance calculators

Camille Laurent

Camille Laurent — Finance writer at OneKitly

Tax · Personal finance

Checked against 2 sources

View profile →
In short

In a geometric sequence each term is the previous one multiplied by a fixed ratio, and the effect of that ratio compounds rather than accumulates. Thirty terms at 7 % growth take a starting value of 1 to 7.11 and sum to 94.46. Thirty terms at 2 % reach only 1.78; thirty terms at 12 % reach 26.75. The rate is six times larger in the second comparison and the outcome is fifteen times larger, because the exponent does the work. This is also the reason a modest-looking difference in an annual return matters far more over a career than over a year — and why quoting growth without a horizon says almost nothing.

Advertisement

Over thirty terms, 2 % growth multiplies a starting value by 1.78 and 12 % multiplies it by 26.75. The gap is not six times, it is fifteen.

The sum is dominated by the last few terms

In the tripling sequence, the eighth term alone is 4 374 out of a total of 6 560 — two thirds of everything, from one term out of eight. That concentration is the signature of geometric growth and it has a practical edge: a project whose output grows at a steady multiple spends most of its life producing very little, and the impression of stagnation is arithmetically correct right up until it is not. The reverse is equally true of decay. At a ratio of 0.7, a value falls to 4 % of its original after nine steps, and by then the remaining terms contribute almost nothing to any total that includes them.

Adding versus multiplying, over the same span

An arithmetic sequence adds the same amount every step and a geometric one multiplies by the same factor, and over a short span they can look alike. Over thirty steps they do not: a fixed addition produces a straight line, and a fixed multiplication produces a curve that eventually leaves any straight line behind, whatever the slope. This is why savings advice separates the contribution from the return — one is arithmetic and the other geometric, and only the second gets better the longer it runs. Someone comparing a scheme that adds a fixed sum with one that multiplies by a modest ratio is comparing two different kinds of function, not two numbers.

Sum of all thirty
Thirty terms, four ratios
RatioLast termSum of all thirty
1.02 (2 % growth)1.7840.57
1.07 (7 % growth)7.1194.46
1.12 (12 % growth)26.75241.33
3 (tripling each step)4 374 at term 86 560

Worked with our own calculator

Geometric sequence calculator

Given

First term (a)
4
Common ratio (r)
6
Number of terms (n)
16

Result

nth term
1,880,739,938,000
Sum of terms
2,256,887,926,000

These figures are produced by the calculator below, not typed in by hand — they are recomputed whenever the tool changes.

Run it on your own figures →
Advertisement

Frequently asked questions

Why is the sum of thirty 7 % terms only 94 and not larger?
Because the sum counts every term, and most of them are small. Starting from 1, the early terms hover just above 1 while only the last handful approach 7, so the running total accumulates slowly and finishes at 94.46. The relationship between the last term and the sum is worth remembering: for a growth ratio r, the sum is roughly the last term divided by r minus one, so at 7 % the sum is about thirteen times the final term. That ratio shrinks fast as growth rises — at 12 % it is nine, and at a ratio of 3 it is under two.
Does a ratio below 1 make the sum finite forever?
Yes, and that is one of the more useful facts in the subject. When each term is a fraction of the last, the total converges: at a ratio of 0.7, an infinite number of terms starting from 1 000 sums to 3 333, and the first ten already reach 3 239 — 97 % of the eventual limit. The same convergence underlies the present value of a perpetual income stream, the total distance travelled by a bouncing ball, and the reason a repeating decimal is a fraction. Above a ratio of 1 nothing converges, which is why perpetual growth models always contain a term the modeller has to keep below the discount rate by hand.

Articles you may find interesting

All guides →

Related tools

Sources

Spotted a mistake in this article?