Osmotic Pressure Counts Particles, Not Molecules
Gepubliceerd op 19-10-2026 · 3 min leestijd · Dagelijkse calculators
Sofia Nunes — Redacteur gezondheid en welzijn bij OneKitly
Voeding · Vochtinname
Getoetst aan 2 bronnen
Osmotic pressure is the van 't Hoff factor times the molarity times the gas constant times the absolute temperature — an equation with the same shape as the ideal gas law, and for the same reason: what matters is how many independent particles are knocking about, not what they are. A 0.15 M solution of a salt that dissociates into two ions produces 7.64 atmospheres at body temperature, and a 0.30 M solution of something that stays whole produces exactly the same 7.64. That is why the label on physiological saline says 0.9 per cent: 9 grams of sodium chloride per litre is 0.154 M, and because each unit gives two ions the solution behaves as though it were roughly twice as concentrated.
0.15 M of a salt that splits in two and 0.30 M of one that does not give the identical 7.64 atmospheres. Only the particle count reaches the membrane.
The factor of two is not quite two
Taking sodium chloride at a clean factor of 2 gives 0.308 osmoles per litre for a 0.9 per cent solution, which is noticeably above the figure usually quoted for blood. The gap is real chemistry: in solution a fraction of the ions spend part of their time paired up rather than moving independently, so the effective factor is nearer 1.85 than 2, and 0.154 × 1.85 comes to 0.285 — which lands where it should. The lesson generalises. The van 't Hoff factor is the number of particles that actually behave independently, not the number written in the formula, and it drifts downward as concentration rises and the ions crowd each other.
Temperature matters, but less than you would guess
The equation uses the absolute temperature, so the twelve degrees between a laboratory bench at 25 °C and a body at 37 °C are twelve parts in about three hundred: the same solution goes from 7.34 to 7.64 atmospheres, four per cent. Anyone expecting a big swing is thinking in degrees Celsius, where twelve out of twenty-five looks like half as much again. Working in kelvin is not a formality here; it is what keeps the arithmetic honest, and it is the same reason a tyre pressure barely moves between a cold morning and a warm afternoon while intuition says it should.
| Solution | Particles per litre | Pressure |
|---|---|---|
| 0.15 M, splits in two | 0.30 osmol | 7.64 atm |
| 0.30 M, stays whole | 0.30 osmol | 7.64 atm |
| Same salt at 25 °C | 0.30 osmol | 7.34 atm |
Uitgewerkt met onze eigen calculator
Osmotische-drukcalculator
Gegeven
- Molariteit (mol/L)
- 0,3
- Temperatuur
- 74
- Eenheid temperatuur
- K
- Van 't Hoff-factor (i)
- 2
Resultaat
- Osmotische druk (atm)
- 3,643
- Druk (kPa)
- 369,162
- Druk (mmHg)
- 2.769
Deze cijfers komen uit de calculator hieronder, ze zijn niet met de hand ingetypt — ze worden opnieuw berekend telkens als de tool verandert.
Reken het door met je eigen cijfers →Veelgestelde vragen
- Why is the pressure so large?
- Because it is the pressure that would be needed to stop osmosis completely, not a pressure anything actually experiences. Seven and a half atmospheres is the push required to hold water back against a membrane separating that solution from pure water, and nothing in a glass or a cell is under that load — the two sides are normally close enough in concentration that the net difference is small. The number becomes real in reverse osmosis, where a pump genuinely has to exceed it: forcing fresh water out of seawater means beating roughly twenty-five to twenty-eight atmospheres, which is most of the energy bill of a desalination plant.
- Is this the same thing as boiling point elevation?
- It is the same family. Osmotic pressure, boiling point elevation, freezing point depression and vapour pressure lowering are the four colligative properties, all of which depend on how many dissolved particles are present and not on what they are. A mole of sugar and a mole of urea do the same thing to all four; a mole of table salt does roughly twice as much to all four. The practical difference is sensitivity: dissolving something raises the boiling point of water by a fraction of a degree per mole per kilogram, while the same solution generates atmospheres of osmotic pressure — which is why the second is a technology and the first is a curiosity.
Artikelen die je misschien interesseren
Alle gidsen →Vergelijkbare tools
Bronnen
Een fout in dit artikel gezien?